I’m new to 3D printing and CAD, it’s not the best looking, I was going for fast printing. I borrowed a couple of files from the internet to get the dimensions of the charger and the thunderbolt.

  • Tolookah@discuss.tchncs.deEnglish
    29·
    10 months ago

    You might want to print it laying down, so the layer lines aren’t at the breaking to get stuck inside your laptop , but nice altogether! My charger has long died, and I’m using a USB c to mag charger that mostly works (and still disconnects if you look at it funny)

    • dashydash@lemmy.worldOPEnglish
      51·
      10 months ago

      Sounds like a good idea, thanks! I was planning on printing a new one because the thunderbolt plug is a little long, I’ll see how it goes lying down.

      I really dislike these magnetic chargers, it has been bothering me since I bought this laptop in 2015, it’s so unreliable.

      • nezbyte@lemmy.worldEnglish
        8·
        10 months ago

        Lying down would be hard to print due to the hollow cavity where the charger goes. You could split it into two separate sections and then glue it together. Easier solution is to model or drill a 2mm hole through the part and glue a piece of filament in place to give it some strength.

        • wjrii@kbin.social
          2·
          10 months ago

          Tree supports and careful use of an exacto knife could also make it work. Post processing can be a bit much sometimes, but it doesn’t have to be the enemy either.

      • nilloc@discuss.tchncs.deEnglish
        5·
        10 months ago

        The right angle MagSafe chargers are much better if you can find one. They have less leverage in the magnets, plus the cord can come out the back of the laptop, or along side the side, which usually fits better in my use cases.

    • dashydash@lemmy.worldOPEnglish
      2·
      10 months ago

      This one still works good enough, until it stops working, it’s ugly 3d printed adapters 🤷🏻

      • dual_sport_dork 🐧🗡️@lemmy.worldEnglish
        3·
        10 months ago

        Never cave in to the cop-out of what can be delivered by Amazon tomorrow, when you can spend days designing, prototyping, and printing it right now!*

        * Definition of “right now” subject to terms and conditions.