That seems to be it! Or “JST-PH”? Not sure what the difference is between PH and PHR-5. 2mm pitch seems to be it at least, and plastic tabs seem to be at the right place:
(Backside of PCB from pictures before)
Just order some of the generic ones I find for " JST-PH" on aliexpress and pray? You are a great help, thank you!
As far as I know are the “PHR” series connectors a variant of the “PH” connectors. They also have a 2.0 mm pitch, but they differ slightly in their housing design. The primary difference in the “PHR” connectors is the presence of a latching feature on the housing. This latch helps to secure the connector halves together, providing additional stability and preventing accidental disconnections.
That seems to be it! Or “JST-PH”? Not sure what the difference is between PH and PHR-5. 2mm pitch seems to be it at least, and plastic tabs seem to be at the right place:
(Backside of PCB from pictures before)
Just order some of the generic ones I find for " JST-PH" on aliexpress and pray? You are a great help, thank you!
Found these over at Amazon: https://amzn.eu/d/6HDzJIR
Can’t say for sure if it’s a full match, but as far as generic goes - maybe this is faster than waiting for AliExpress at least.
As far as I know are the “PHR” series connectors a variant of the “PH” connectors. They also have a 2.0 mm pitch, but they differ slightly in their housing design. The primary difference in the “PHR” connectors is the presence of a latching feature on the housing. This latch helps to secure the connector halves together, providing additional stability and preventing accidental disconnections.
Check out this page: Common JST Connector Types – Matt’s Tech Pages
farnell.com | PHR-5 Technisches Datenblatt
I ordered some of these:
With a little bit of luck it should be an easy repair. Thanks again!