I’ve got an Ender 3-pro with cr-touch and plastic washers instead of springs. I sanded down the washers to manually level the bed to var of 0.372.
When I adjust the z-offset it prints great but I need to adjust it before every single print. It stays within a fairly narrow range, -1.11 to -1.37 but if I don’t do that adjustment, the print usually fails.
I preheat the bed and nozel before adjusting it. None of the screws seem to be loose. The nozel doesn’t jiggle around. I tightened down the screws for the z-actuator.
What else could I be missing?
I still have this problem. The right side of the x axis is loose on the upright for me. Adding a dual z-axis didn’t help much, it still sacks sometimes. Next step is to add a cr-touch or completely rebuild. I’d also like to hear some other ideas for permanent fixes