• skilltheamps@feddit.de
    link
    fedilink
    English
    arrow-up
    5
    ·
    1 year ago

    How do you handle residual filament on the nozzle from previous prints? Or if you heat it up to get to nozzle itself to touch the bed, do you get dabs of plastic distributed around your bed?

    • LazaroFilm@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      edit-2
      1 year ago

      I preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.

    • IMALlama@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      My probe hits my z endstop, so similar idea. I preheat my probe and manually wipe it before I home. Any ooze doesn’t really make a difference in first layer. At some point I’ll print a purge bucket and nozzle brush…

      My endstop is just a metal rod, but since it’s cold filament doesn’t stick to it. If I were probing my bed I would probably want a hot nozzle and cold bed.

      • skilltheamps@feddit.de
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        Cold bed can be a problem sometimes due to the bed warping with temperature. I myself always probe with the bed at printing temperature for this reason