Megaquarium, Big Pharma, Bus Simulator 21.

All of them are solid.

Wait, sorry. What’s supposed to touch the bed? The hot end or the ABL sensor?

Yeah, this was my assumption (the probe should hit before) - I just wasn’t sure if they were supposed to offset just enough with the adjustable probe to end up being in-line with the nozzle. The instructions are… not great.

Oh my god, same issue here. I’m just ready to use Lemmy (or KBin, or anything) and not constantly read how much better it is than Reddit and how Reddit is going down a death spiral. Let’s just move on and provide our own content.

We can discuss where the money comes from, but the idea isn’t pie-in-the-sky wild. I don’t disagree with you.

It makes sense if you think about it (assuming my thoughts are correct, I’m in the US). If you’re employed, you are contributing through your taxes. Just because you’re unemployed, it doesn’t mean your contributions pause. Now, should they? That’s a good question, but the current implementation makes sense. I imagine it does incentivize people to look for employment.

Sorry, yeah I realized my post was super light on info - the printer is in the basement and far away :)

Where I’m at:

• Multiple USB A <-> Micro-USB cables were tried
• RPi4 turns on, I can access Octoprint just fine. Octoprint says it could not recognize any connected printer
• E3Pro turns on just fine, is completely stock and has not been modified in any way.