(I have carbon monoxide detectors that are not going off)

I have smoke detectors that are incorporated into my home alarm system. The other day, the one by my front door went off for no apparent reason, twice, and when I changed the batteries, it started alarming again immediately.

there was absolutely no reason for it, there were no open windows or doors nearby, it just went off. so, my alarm company replaced it. installed the new smoke detector yesterday and… it just went off again. completely different smoke detector.

there’s absolutely nothing in my house that could produce carbon monoxide, but I have separate CO detectors anyway that aren’t going off. there’s no smell, there’s nothing visible, and these are those electro optical photoelectric style ones.

  • pelletbucket@lemm.eeOP
    17·
    5 months ago

    The weird thing is, it alarmed three times in its current position, but when I changed the battery, it started alarming in my hands in a completely different room, which I already had two other smoke detectors in it that weren’t going off.

    and there’s no gas. I live outside Miami

    • Fosheze@lemmy.worldEnglish
      27·
      5 months ago

      This makes it sound like it’s probably just a defective detector. Swap it with one that hasn’t been going off and see if that one starts going off too. If it doesn’t then odds are something just failed in it.

      You could also just try blowing some air through it to blow out any dust. But it shouldn’t be that dusty after only a year so I’m still leaning towards defective.

    • bradorsomething@ttrpg.network
      2·
      5 months ago

      Sounds like a bad unit, try replacing it. The fact it’s going off elsewhere and no other detectors go off says it’s the unit.

      I missed that you changed units, check your wires.

      If the new unit starts going off, you may have a switched wire between your signal (red) and your hot (black) that fried the unit.

        • bradorsomething@ttrpg.network
          1·
          5 months ago

          Then some signal from the base unit alerts all units that one detector has gone off, to alarm the home. Either the base unit is sending a false signal, or some outside signal is mimicking the signal.

          Personally I’d install a standalone detector in that spot.

          • pelletbucket@lemm.eeOP
            1·
            5 months ago

            I’m slowly concluding this might have something to do with my Ring Doorbell and a new Chime I’ve added to that system, or cobwebs. I’ve thoroughly dusted this corner of the wall and ceiling now, and the chime stopped working anyway so